If you shop at Amazon.com (for anything), use this link to support FordTaurus.net!

Has Anyone Recreated the Factory Center Console?

Post Reply
9C3
Regular Member
Posts: 14
Joined: Tue Jul 03, 2018 2:01 am

Has Anyone Recreated the Factory Center Console?

Post by 9C3 » Sun Jan 13, 2019 9:19 pm

Hello, I was looking to see if anyone on here has had success recreating the factory center console for their PI. Wanted to see how feasible, economic, and difficulty of the entire job. Thanks


Soda_can_dan
Regular Member
Posts: 58
Joined: Sun Feb 04, 2018 11:58 am
Vehicle: 2015 FORD TAURUS POLICE INTCPR

Re: Has Anyone Recreated the Factory Center Console?

Post by Soda_can_dan » Mon Jan 14, 2019 11:38 am

It’s very easy. Only hard part is finding a good condition donor. I wound up buying new factory cup holder panels cause the donor one I picked up had scuffed up surfaces. In addition to finding a good one, you need wire it if you want the ambient lighting and the 12v plug. You also need to buy Ford part number DG1Z-5404608-JA to fill the gap you see in mine where the 12v plug should be (haven’t bought it yet). The PI ac/radio control is a little shorter than a civilian Taurus. So only that part number can fill that gap.
Attachments
CD069BB7-DD22-437D-98A1-B068E98975DF.jpeg
CD069BB7-DD22-437D-98A1-B068E98975DF.jpeg (183.15 KiB) Viewed 55 times

Soda_can_dan
Regular Member
Posts: 58
Joined: Sun Feb 04, 2018 11:58 am
Vehicle: 2015 FORD TAURUS POLICE INTCPR

Re: Has Anyone Recreated the Factory Center Console?

Post by Soda_can_dan » Mon Jan 14, 2019 11:40 am

Almost forgot. You need to make sure you get the mounting brackets for the console. There are a total of three brackets but you only need the front and back brackets, not the middle one.

9C3
Regular Member
Posts: 14
Joined: Tue Jul 03, 2018 2:01 am

Re: Has Anyone Recreated the Factory Center Console?

Post by 9C3 » Mon Jan 14, 2019 8:28 pm

More specifically, can you take an SE, SEL, or SHO center console and reconfigure it to a PI console as shown in this photo?
Attachments
cc.jpg
cc.jpg (104.18 KiB) Viewed 42 times

Soda_can_dan
Regular Member
Posts: 58
Joined: Sun Feb 04, 2018 11:58 am
Vehicle: 2015 FORD TAURUS POLICE INTCPR

Re: Has Anyone Recreated the Factory Center Console?

Post by Soda_can_dan » Wed Jan 16, 2019 12:37 pm

Yes, you just need to get those cup holders and dash pieces in that photo. They are all interchangeable. Unfortunately I’m not familiar with those part numbers but I’m sure your local Ford parts department will help you with that.

Post Reply