If you shop at Amazon.com (for anything), use this link to support FordTaurus.net!

Camber Kit & Bolts Question

Post Reply
User avatar
BigDogg
Regular Member
Posts: 83
Joined: Thu Jun 26, 2014 8:26 am
Vehicle: 2007 Ford Taurus SE

Camber Kit & Bolts Question

Post by BigDogg » Fri Apr 07, 2017 9:12 am

I know I am on the wrong forum but hear me out. I drive a 2007 Taurus SE. I wanted lowering springs for it but most companies make lowering spings for the fourth generation Taurus. Eibach did make Pro Kit springs for the 96-98 Taurus & SHO but they have been long since discontinued. I found a company in Australia called King Springs that still make them and they also for from 99-07 Taurus because they share the same struts and springs.
I just ordered them but it will take a few weeks to get here. My question is do I need to get camber plates & bolts for this setup to keep the alignment in spec. Some say no because it is only one inch. Others say it doesnt hurt to have them just in case. Any thoughts?


Post Reply