If you shop at Amazon.com (for anything), use this link to support FordTaurus.net!

Search found 917 matches

by warment
Thu Mar 14, 2019 6:15 pm
Forum: 1996-1999 Ford Taurus & Mercury Sable (3rd Generation)
Topic: surging 1997 Taurus
Replies: 4
Views: 170

Re: surging 1997 Taurus

My mom's 2003 Vulcan had a rotted pcv elbow on the top left side of the motor when facing the car. Remove yours and take a look inside if you have the same setup.
by warment
Thu Mar 14, 2019 6:08 pm
Forum: Everything Else
Topic: 2006 Ford Five Hundred - final days
Replies: 3
Views: 254

Re: 2006 Ford Five Hundred - final days

I know what you mean. My 2005 has a huge hole on the right side and the left side has bubbled and will have a hole soon. I believe the problem was due to bad prep work, since mine bubbled between the metal and the paint. Oh well. I have 319k onine now and will continue running it until it dies or a ...
by warment
Thu Jan 31, 2019 6:43 pm
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: Door Latch Lubrication
Replies: 5
Views: 231

Re: Door Latch Lubrication

Wow. Good luck. I am about to go over 317k on my five hundred. I bought my mom a 2003 taurus Vulcan in 2003. Still has it and it runs great. Has a leaky timing cover though.
by warment
Thu Jan 31, 2019 1:58 pm
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: Door Latch Lubrication
Replies: 5
Views: 231

Re: Door Latch Lubrication

Then the pass door acted up this morning...wouldn't latch...so I sprayed it along with the other doors and trunk. I honestly think the problem is caused by the rubber coating on the mechanism. I have cut and pulled out what I could on other cars. Seems to help.
by warment
Thu Jan 31, 2019 1:57 pm
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: Door Latch Lubrication
Replies: 5
Views: 231

Re: Door Latch Lubrication

I just went through this on my driver's door 2 days ago. I sprayed the latch/mechanism with silicone spray and didn't remove anything. It worked well this morning at less than 10 degrees.
by warment
Fri Oct 19, 2018 4:38 am
Forum: 2010-newer Ford Taurus (6th Generation)
Topic: who has highest mileage?
Replies: 15
Views: 2406

Re: who has highest mileage?

Almost up to 310k on my 2005 500 now...
by warment
Fri Sep 14, 2018 12:03 pm
Forum: 2010-newer Ford Taurus (6th Generation)
Topic: Overheating, second verse
Replies: 2
Views: 579

Re: Overheating, second verse

Bad coolant temp sensor? What is your temp gauge reading on the dash?
by warment
Tue Aug 28, 2018 7:44 am
Forum: Under the Hood
Topic: 05 ford five hundred stalling
Replies: 8
Views: 885

Re: 05 ford five hundred stalling

Dumb question...did you disconnect batt, wait 5-10 mins, reconnect batt, turn key forward (but not start) to allow for throttle body to sweep and recalibrate?
by warment
Tue Aug 14, 2018 5:48 pm
Forum: Under the Hood
Topic: 05 ford five hundred stalling
Replies: 8
Views: 885

Re: 05 ford five hundred stalling

Was the car doing this before you installed new plugs? If not, the upper intake must not be sealing like it should.
by warment
Sat Aug 11, 2018 5:06 am
Forum: Under the Hood
Topic: 05 ford five hundred stalling
Replies: 8
Views: 885

Re: 05 ford five hundred stalling

Sounds like you have a leak on the upper intake to me.
by warment
Sun Jun 24, 2018 8:15 am
Forum: 2008-2009 Ford Taurus & Mercury Sable (5th Generation)
Topic: Front end popping 2009 Taurus
Replies: 5
Views: 633

Re: Front end popping 2009 Taurus

Did they replace the upper strut bearings as well? I would guess this is your problem.
by warment
Fri Jun 08, 2018 10:32 am
Forum: Everything Else
Topic: High mileage 500
Replies: 7
Views: 1586

Re: High mileage 500

I have 303k on my 2005 Ford Five Hundred. Same engine and no trans rebuild.
by warment
Mon May 28, 2018 9:29 am
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: 2006 montego hard shift.
Replies: 1
Views: 353

Re: 2006 montego hard shift.

Likely due to a bad transaxle roll resistor bushing. Pop the hood and look for tears in the rubber bushing.
by warment
Sun May 13, 2018 8:40 am
Forum: Under the Hood
Topic: 2005 Taurus SE missfire
Replies: 1
Views: 362

Re: 2005 Taurus SE missfire

My ford five hundred did the same thing when an oxygen sensor went bad. No cell for quite a while but got one for lean bank 1 eventually.
by warment
Fri Mar 23, 2018 1:32 pm
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: 2004 Taurus runs rough when taking off
Replies: 3
Views: 531

Re: 2004 Taurus runs rough when taking off

Vulcan? If so check the rubber pcv elbow on top of the intake. My mom's had a crack in it that caused the car to run badly.
by warment
Fri Jan 12, 2018 6:02 am
Forum: Everything Else
Topic: Just passed 300k
Replies: 2
Views: 744

Just passed 300k

300k.jpg
300k.jpg (123.71 KiB) Viewed 744 times
by warment
Fri Jan 12, 2018 6:01 am
Forum: Five Hundred / Montego Reviews
Topic: Donated my Ford 500
Replies: 2
Views: 558

Re: Donated my Ford 500

Just went over 300k on my 2005...great car...
by warment
Thu Jan 04, 2018 11:34 am
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: 2006 Taurus rough running issue
Replies: 8
Views: 7302

Re: 2006 Taurus rough running issue

Dorman 46035 is the part number for the rubber pcv elbow I used on the Vulcan ohv.
by warment
Thu Jan 04, 2018 8:48 am
Forum: 2000-2007 Ford Taurus & Mercury Sable (4th Generation)
Topic: 2006 Taurus rough running issue
Replies: 8
Views: 7302

Re: 2006 Taurus rough running issue

Is it a Vulcan ohv motor? If so, check the rubber pcv elbow that goes into the intake. Just went through this on my mom's 2003 Taurus. She had a stuck lean bank 2 sensor 1. Replaced it, code went away, but car still ran like crap. She had a bad leak on this elbow. Used a Dorman replacement part for ...
by warment
Mon Jan 01, 2018 2:53 pm
Forum: Everything Else
Topic: Ford 500 brake slider pins
Replies: 10
Views: 1734

Re: Ford 500 brake slider pins

So I bought 2 brck-5086-b caliper kits and 1 brpk-5771 pad attach kit