If you shop at Amazon.com (for anything), use this link to support FordTaurus.net!

Search found 3 matches

by frank t
Thu Mar 17, 2011 2:04 pm
Forum: Under the Hood
Topic: Engine mount shot
Replies: 117
Views: 63441

Re: Engine mount shot

Problem is I do not/cannot get a wrench up under the crossbar to loosen nut. Not much clearance under there. Anyone with a suggestion??[/quote]

Just remove the whole crossbar. It's held in place by 4 bolts 2 on each side at the ends.takes @ 10 minutes!!
You'll NEVER get that center bolt undone!!
by frank t
Thu Mar 17, 2011 1:22 pm
Forum: Under the Hood
Topic: Transmission slams into gear after delay
Replies: 8
Views: 2145

Re: Transmission slams into gear after delay

I just completed the "six buck Volvo" fix!! Fixed the bumping shifts, and greatly reduce my 1500 RPM vibration issue too!! I almost went crazy trying to unbolt the top bracket near the firewall, until I noticed that the whole cross bar it's attached to unbolts easily with 4 bolts. Just pull the enti...
by frank t
Thu Dec 16, 2010 3:55 pm
Forum: Under the Hood
Topic: 1500 RPM vibration (07 500 sel 6speed fwd)
Replies: 0
Views: 271

1500 RPM vibration (07 500 sel 6speed fwd)

My car, an '07 6 speed FWD 500 SEL has developed an annoying vibration in the 1300-1500 RPM range in any gear.. The car has @ 50,000 miles, and was fitted with a new set of Bridgestone tires @ 10,000 miles ago. This is very annoying especially around town where that rev range is used a lot...I'm sus...